Separate names with a comma.
He has, and there is better parts availability for it than this wagon, however, for the most part companies skip over the 1957-1960 years, and the...
Lots of other cars use these, but the shape isn't even going to be close. I might as well just buy spring steel rod and bend it myself, except I'd...
Phoenix Spring emailed me after I resent the email and addressed it to a couple of their engineers. They said that they do not do that type of...
It's not looking good so far. I emailed a few local places and sent a picture of the torsion bar. Only IDC Spring responded, and they told me that...
I just emailed Auveco themselves to see if they make them or can make them.
Hmmm... it may be that the original style just isn't being made anymore (in that size). Ugh. I guess I'll just have to use a sealant around the...
I found a clue... these were made by Auveco, and other auto manufacturers used them in the size I need, as well. Now, I just need to find some,...
They may work, but the ones that were in the tailgate were exactly the type shown in the first two pictures. It's baffling that they sell the...
I need to install the F O R D letters on the hood and tailgate of a 1965 Ford Country Sedan, and the emblem on the tailgate. They are a friction...
Green Sales Co. says that they don't have the fuel filler door seal, and can't find a part number for it.
Green Sales Co. says the Ford part number for the torsion bar is C5AZ7144890A, which is different than what the book says. I have contacted some...
Very interesting! There are a couple spring manufacturers in town I'm going to contact first to see if they are up for the job of replicating the...
Desert Valley Auto Parts in Casa Grande, AZ has one. I just saw it today, but it might have some scratch marks from the window regulator pins...
Desert Valley Auto Parts in Casa Grande had a 1965 Ford wagon. I went there and they told me at first that they didn't have it, which was really...
Thanks for that diagram. I was curious how they made it work in 1966. Unfortunately, it's too short on the left side, and the right side is the...
In this ad from 1965, you can see the torsion bar sticking out of the tailgate and attached to the body on the right side. [ATTACH] In 1966 it...
In 1966 they switched to a tailgate that drops down and also swings away. The 1965 torsion bar goes through the outside of the tailgate and...
Unfortunately, the lowest spot on the tailgate is the pinch weld, so it will fill up with water no matter what. Poor design. But, drain holes will...
I'll ask Green Sales Co. about it. I think it's a 2 1/16" filler neck, so a 2" grommet should work.
The shop manual doesn't even show a part number for the wagon fuel filler seal. I tried to find new old stock, but that doesn't seem to exist, and...
