Separate names with a comma.
Did you test engine running at temp ? cycling brake and overdrive switch if applicable for WOT test ?
Your best investment would be a scanner like e-bay item # 231623010278 to check codes. Cheaper than a mechanic on an hourly rate. Never hurts to...
Worked on many Fords and never had a computer take that much time to adjust to a part change.
Possibly a bad coolant temp sensor telling computer wrong. Like an old car with choke not working. You say its ok when warmed up.
Behind the push button there is a spring that returns the push rod. I have found that removing the latch, door handle, and lock to clean the old...
They have 15" under Galaxie
Same problem with my wagon and a VW bus I restored. Had a radiator shop clean and line with no problems. Some radiator shops will do this.
I've used Bumper-Boyz for 56 Merc , 59 Ford, and the wagon with no problems. The key is a good core if it's not a common auto.
It should be anodized and very hard to get finish like nos piece due to age. Might have to break surface of new piece to get the finish similar...
x 3 on egr spacer major problem with these years .Just omitted one on a 74 400 with same symptom. If you haven't removed it to examine you need...
With the older Fords if you ground your sending unit wire it should go to full. There also is a constant voltage regulator on back of instrument...
Parts for the big 67 Fords are hard to find. Is your guage bad or could it be your sending unit ? Tuesday I'll be talking to a guy that maybe able...
Are we talking fuel guage , fuel pump, or sending unit for your 67 ?
For what ?
Really nice and be proud of your work because you did it. The most important person to make happy is you. To many just write checks and never know...
The coil gets 12v to start then the resistence wire comes in to play cutting voltage for running. That is the purpose of them showing on a...
Prime example just yesterday I did a tune-up on 1974 Merc with a 400ci. which from the factory was electronic ignition and had the control module...
I suggest you start at ignition switch and strip all insulation on the wires in your ignition system. Your starter solenoid should have both the S...
:Welcome:Clean ride, enjoy.
How have you determined that water is in the gas?
