How to remove turn signal housings on a 1956 Ford Country Sedan

Discussion in 'General Automotive Tech' started by TomS, Jul 7, 2021.

  1. TomS

    TomS Member

    Joined:
    Jul 7, 2021
    Messages:
    3
    Likes Received:
    2
    Trophy Points:
    5
    I'm installing a new wire harness in my '56 Country Sedan and am stumped on how to remove the front turn signal housings. I have the three bolts on the bottom removed and the units are loose but there is still one (?) bolt holding them in place near the outside of the housings. If I can't figure out how to remove something so obvious, I probably shouldn't be rewiring the entire car. But we're committed now, there's no going back.
     
  2. wagoninsane

    wagoninsane Well-Known Member

    Joined:
    Nov 1, 2015
    Messages:
    1,237
    Likes Received:
    549
    Trophy Points:
    322
    Wagon Garage:
    1
    Location:
    Friendship Ny.
    Welcome to the forums TomS, Hang loose and someone will probably be able to help you out with your situation. In the mean time go to the Welcome Wagon thread and introduce yourself and your wagon! We love pictures so include a few if possible. Again welcome and hope you enjoy your stay!....Longroofs Rule!
     

Share This Page