Separate names with a comma.
I dug deep and found that GM, does in fact, spec DEX2 ATF for their NPA833/MV440 trans. I did add some Lucas ATF trans fluid additive. Looks like...
I came across a thread for adding a sway bar to my wagon from a Ford. Wow, it did work great. Plucked a sway bar from a full sized mercury, bought...
I ordered a front and rear spring kit from Canuck Auto. 1.5" drop front and rear. They had lower kits but I want to be able to drive over a speed...
Someone else told me something similar. That person suggested using GM posi additive/friction modifier to quiet up OD. Noise is not obnoxiously...
Well, it's all wrapped up. 4 speed is in, interior wrapped up and I took it for a cruise around the block. I do have to finish up the trans...
I finished up that install this weekend. I rotated the axle mounted bushing slightly rearward. This allowed the endlinks to be more vertical at...
Wow this is an old tread. Chances are you may not answer but here goes; I am doing the same mod to my 88 Caprice wagon. I drilled holes into the...
On my 1959 I actually had to pop it out in front of the rear tire. I tucked the pipe {no tip} up and out of sight as best I could with a downward...
I did the same exhaust tip treatment on my 84 Olds too. right behind the rear wheel.
I know right! It looks great and it is far easier/cheaper to make as you do not have to go another 2' back on both sides to dump by the bumper.
Battled with the carpet. Needed to trim away material to allow the shifter housing to poke through. Box cutter and patience was all that was...
We will see who is reading this with all this Covid shit going on BUT we must keep going forward. With all the self isolation happening it is a...
More Bread and Butter type maintenance. I had my disks cut at my buddies shop and I went through the trouble of rebuilding both calipers with new...
A little less than $500 Canadian. 2 mufflers, 2 4" stainless flex pipes, 4 U bends, 3 90 degree bends, 3 45 degree bends, 8' straight pipe. All...
I was on the 348/409 fence for a bit as well. My engine builder has several 348 cores and one 409. LT1/T56 was chosen for the ease of ownership,...
Oh, I did have to modify the Z bar slightly as well. Arm closest to the engine block was pie cut about 1/4" and bent to make it straighter. In...
Took a brake and now pushing to get the wood-grain wonder on the road for spring. After agonizing about suspension drop, I finally settled on...
Looks more Hungry than anything. lol
I would love to take credit for it but alas I cannot. lol
Oh, I also asked my neighbor, Steve R, to make me a new shift knob. He's extremely handy with his lathe. I salvaged the shift pattern medallion...