Duals for Custom Cruiser queation

Discussion in 'General Automotive Tech' started by dodgeguy, May 3, 2011.

  1. dodgeguy

    dodgeguy Well-Known Member

    Joined:
    Jul 4, 2007
    Messages:
    596
    Likes Received:
    5
    Trophy Points:
    69
    Wagon Garage:
    1
    Location:
    Southport, NC
    I am thinking about having dual exhaust installed on my '91 Olds Custom Cruiser. The tranny cross member has a hump in it for the right side only. Will a later model cross member from an LT1 work?
     
    dodgeguy, May 3, 2011
    #1
  2. The Stickman

    The Stickman Well-Known Member

    Joined:
    Nov 26, 2008
    Messages:
    1,316
    Likes Received:
    9
    Trophy Points:
    111
    Wagon Garage:
    3
    Location:
    Lehigh Valley pa
    Just mod the old one. That is what I did.
     
    The Stickman, May 3, 2011
    #2
  3. dodgeguy

    dodgeguy Well-Known Member

    Joined:
    Jul 4, 2007
    Messages:
    596
    Likes Received:
    5
    Trophy Points:
    69
    Wagon Garage:
    1
    Location:
    Southport, NC
    My Malibu had a similar crossmember that somebody cut the bottom out of and welded on a piece of flat bar on the top. It worked, but looked a little ragged.
     
    dodgeguy, May 3, 2011
    #3
  4. silverfox

    silverfox New Member

    Joined:
    Feb 18, 2009
    Messages:
    16,780
    Likes Received:
    12
    Trophy Points:
    0
    Wagon Garage:
    1
    Location:
    Wisconsin
    silverfox, May 4, 2011
    #4

Share This Page