|2012-03-12, 04:42 AM||#1|
Join Date: Dec 2010
My Garage: 2Vehicle(s): 1968 belair wagon
installing rear-side-glass ?
Hi guys, i'm gonna get my glass back from the tint-shop tomorrow.
The tailgate window and the side glass have been tinted, and i also have new rubber for the side-glass.
The tailgate is the least problem….just carefully slide it in there and bolt it to the rail
The side glass looks to be a little more challenging ………
Has anyone done this before….and how to pull them in the body…
do you use a rope or something else….
Taking the old glass out, i had to use a knife to cut all the hard/old rubber and lots of silicone.
THX for your tips and tricks..
>>Still looking for a tailgate window crank for my '64 Impala<<
Trapped in time, Surrounded by evil, Low on gas...….
|2012-06-13, 05:59 AM||#2|
I fit the rubber into the window with a length of 3/8th twine in the slot for the window and with someone pushing the "CLEAN" edged window in place, I pull the rope slowly to get the rubber to cover the edge of the window. It takes a bit of practice but if you're careful and patient, its the best way. No need for sealant but it should be clean. Very clean. I have heard that a thin coat of Vaseline along the edge helps but I have never tried it that way.
|Thread||Thread Starter||Forum||Replies||Last Post|
|1971-76 gm fullsize wagon side curved glass||dedsleds||Station Wagons & Parts for Sale||5||2013-01-20 10:03 AM|
|Side Glass||45GUNNER||General Automotive Tech||2||2011-11-30 10:51 AM|
|Wanted:gas tank and driver side glass and vent window for 1959 chevy 2 door wagon||new59||Station Wagons & Parts Wanted||1||2011-04-08 22:25 PM|
|Rear side window trim||johnlindsey81||The Welcome Wagon||1||2010-04-24 20:44 PM|
|Rear Glass Lift Supports||onthewagon||General Automotive Tech||6||2010-03-02 20:34 PM|