Separate names with a comma.
I'm working on the car now. I've been able to get the front accessories on. I have all the body panels I need. The bracketry is powder coated....
Thanks for the replies
The Build Sheet code for the alternator on my '71 Pontiac Grand Safari with the original 455 is "SP," but I can't find which alternator this...
That's a great idea, that wouldn't have occurred to me. I'll definitely go back with that thicker wire. My problem now is I still can't find a...
Thanks guys. This project feels like the never ending story, which I guess make sense since I've had it since 2013 and have barely gotten to...
Progress on the station wagon has been very slow for sundry reasons, some of which I'll address later. One of the reasons was that I needed to...
This is the dipstick with my 700R4. I'm pretty sure it's wrong. I know the picture isn't great, but does anyone recognize what this dipstick might...
Thanks, guys! Hey, Eric! I almost messaged you when I went cross country to see if I could stop in and check out your builds. Because...
Now that The Caprice was relatively "done," despite some minor things like a new door handle, replacing the plastic ring in the steering column...
This post covers a wide span of time. Back in the summer The Caprice's A/C wasn't working great. It was very hot and humid and sometimes on the...
1971 Pontiac B Body. Has anyone made a patch panel for the dog log in front of the rear tire (4 door)? If so, what did you use? Any other panels...
Also, the on on the passenger side is in good shape, but the hole is much lower than on the driver side.
There is a metal plate that screws into the cowl. The rubber slips through the hole of the plate and then sandwiches between the plate and the...
The Caprice is doing pretty good. I've been working on some finishing issues here or there that aren't related to the engine swap, and also...
The drain tube for the cowl that goes behind the driver's fender is rotted. Has anyone made a suitable replacement? What did you use? [ATTACH]...
It's finally time to get started putting The Clam back together. [ATTACH]
I have been dreading this next job for months. Every time I raise the car up I have do so by putting the jack under the differential, otherwise...
Well, the flare is build into the brass fitting, it's not actually on the part where the line goes into the fitting. I installed my 3rd brass...
It's leaking between the trans cooler and the brass fitting. It seeps out the male threads on the brass fitting. Where the hardline screws into...
Thanks guys. This stupid thing WON'T END. The lower transmission line WILL NOT stop leaking. The top one has been no problem. I just have a...